4.1.2 Programming Ways
Going to another program address
After pressing STORE, you can go to another program with either
of the following two methods:
(1)
l
To go to the next larger program address:
Press
Soft 1 (SKP+)
or
VOLUME
V
(DOWN).
l
To go to the next smaller program address:
Press SHIFT +
Soft 1 (SKP-)
or VOLUME A (UP).
(2) To go to a specific program address:
Press END, then enter the Program Address.
Method (1) is useful when you want to perform a series of
programs consecutively. For example, to change the programming
in addresses [000] to [008], use this method. You can move from
[000] to [OOl], from [OOl] to [002], and so on by pressing the
SJCP+ or VOLUME
V
.
You can
move in reverse order from
[008] to [007], etc. by pressing the SKP- or VOLUME A.
This method can also be used to move between neighboring
program groups: For example, you can move between the program
addresses [008] and
[
1001,
[
1161 and [200], and so on. Also, you
can move between the smallest program address [000] and the
largest one [992].
Method (2) is useful when you wish to jump to another program
address. For example, you have just finished with program [006]
and now you want to go to program [301]. Neither SKI?+/
VOLUME V nor SKP-/VOLUME A is convenient in this case.
So you should press END and enter 30 1.
i”
J
Note The
following programming instructions suppose that you have already
entered programming mode and that you will use Method (2).
. .
c
*- ..s
Confirming the entries
You may review the stored programming without making any
changes.
Going back to the operation mode
Two ways are available to go back to the operation mode:
(1) Lift the handset while in programming mode.
(2) When the Initial Message:
SYS- PGM NO? -->
is
displayed, press the PROGRAM (or PAUSE) button.
(To display the Initial Message, press END.)
4-8
System Programming
To Next Page
Loading...
