43 0
System Programming
103
Automatic Access CO Line Group Assignment
Description
Assigns the sequence in which CO line groups will be accessed
when in Automatic Line Access mode. When a user dials the
feature number for automatic line access (default=9) or presses the
L-CO button, an idle line is hunted in the programmed CO line
group order.
Selection
Default
12345678
0
Programming
1.
2.
3.
4.
5.
Enter 103.
Display:
Local Access
Press
NEXT.
CO line group number:
1 through 8,
eight entries (max.) in desired order
Display example: Access:12345678
Enter the CO line group numbers in priority from top to
bottom.
To
delete the current entry, press CLEAR.
To
change the current entry, press CLEAR and the new order.
Press
STORE.
Press
END.
‘7
(
.I
Conditions
l
There is a
maximum
of
eight CO line groups.
Up to eight CO line
group numbers can be entered.
l
Automatic Line Access feature works only if Automatic Route
Selection mode is turned off in program [3 121 “ARS Mode.”
Feature References
Section 3, Features,
Line Access, Automatic
Line Access, Direct
Line Preference - Outgoing
System Programming
d-35
To Next Page
Loading...
