Panasonic KX-TD816 - Walking COS Feature

43
.
System Programming
111
z-.
Caller ID Name Set
. k:
ci3
(i
Description
With Caller ID Service, the calling party is displayed either by its
ID Code or by its name. If the name display is required, use this
program to give a name to a caller ID Code stored in program [ 1 lo]
“Caller ID Code Set.”
Selection
l Location number: 001 through 250
l Caller ID Name:
15 characters (max.)
Default
All locations - Not stored
Programming
1.
Conditions
2.
3.
4.
5.
6.
7.
8.
Enter 111.
Display: Caller ID Name
Press NEXT.
Display:
Location NO?->
Enter a location number.
To enter location number 001, you can also press NEXT.
Display example: OO1:Not Stored
Enter a C+$ler ID Name.
For entering characters, see Section 4.1.3 “Entering Characters.”
To delete the current entry, press CLEAR.
To change the current entry, press CLEAR and the new name.
Press STORE.
To program another location, press NEXT or PREV, or
SELECT and the desired location number.
Repeat steps 4 through 6.
Press END.
There is a maximum of 250 Caller ID Names, which corresponds to a
maximum of 250 Caller ID Codes stored in program [ 1 lo] “Caller ID
Code Set. ”
Each name has a maximum of 15 characters.
Feature References
Section 3, Features,
Caller ID
System Programming
4-43