43
l
System Programming
114
-.
VM Command DTMF Set
ccontd.)
Selection
l
LV-MSG / GETMSG / AA-SVC / V&I-SVC
l
DTMF signal number: 16
digits (max.)
Default
LV-MSG - H; GETMSG - * H; AA-SVC - #8
;
VM-SVC - #6
Programming
1.
Enter 114.
Display
:
VM
Command Set
(7-J
:*..
.I
Conditions
0
2.
Press
NEXT
to program the LV-MSG command.
To
program another command, keep pressing
NEXT until the desired
command is displayed.
Display example: LV-MSG:H
3. Enter a
DTMF signal number.
To
delete the current entry, press CLEAR.
To
change the current entry, press CLEAR and the new number.
4. Press
STORE.
5.
To program another selection, keep pressing
NEXT
or
PFIEV
until the desired selection is displayed.
6.
Repeat steps 3 through 5.
7.
Press
END.
l
A command
signal number can have a maximum of
16
digits,
consisting of
0
through
9,
* ,
#,
FLASH
and
PAUSE.
l
The FLASH
button is available only for
LV-MSG and GETMSG
commands to store “I-I” which means “Home Position.”
l
If “R’ is stored for “LV-MSG,” a mailbox number programmed in
program [609] “Voice Mail Access Codes” or an extension number will
be sent to the VM port (Follow On ID function). If certain codes are
required before and after the ID code, insert ‘73” between the codes, as
“aaaHbbb.” If nothing is stored, it will operate as “H.”
l
If “ * I-l” is stored for “GETMSG,” a mailbox number programmed in
program [609] “Voice Mail Access Codes?’ or an extension number will
be sent to the port succeeding the “ * .”
Feature References
Section 3, Features,
Voice Mail Integration
System Programming
4-47
To Next Page
Loading...
