600
48
0
Extension Programming
Extra Device Port
Description
Extra Device Port (XDP) allows a single line telephone (SLT) to be
connected to the same jack as a digital proprietary telephone
(DPT). This program assigns which jacks are XDP. The SLT and
DPT of the programmed jack work as independent extensions.
Selection
l
Jack number: XX-TD8 16;
01 through 16, * ( *
=a11 CO jacks)
KX-TD 1232;
01 through 64, * ( *
=a11 CO jacks)
l
Disable / Enable
Default
All jacks - Disable
Programming
1.
2.
3.
4.
5.
Press
STORE.
6.
To program another jack, press
NEXT
or
PREV,
or
SELECT
and the desired jack number.
7.
8.
Enter 600.
Display:
XDP Assign
Press
NEXT.
Display:
Jack NO?->
Enter a jack number.
To
enter jack number 0 1, you can also press NEXT.
Display example: #Ol:Disable
Keep pressing
SELECT
until the desired selection is
displayed.
Repeat steps 4 through 6.
Press
END.
Conditions
0 The extra Device Port feature must be assigned “Disable” for DSS
ports.
l
In the case of KX-T’D 1232, jack numbers 01 through 32 are for the
Master System and 33 through 64 are for the Slave, if available.
l
To assign all jacks to one selection, press the * key at step 3. In this
case, the display shows the contents programmed for Jack 01.
l
Immediately after changing your assignment, the changed setting may
not work for a maximum of eight seconds.
Feature References
Section 3, Features,
Extra Device Port (XDP)
4- 104
System Programming
To Next Page
Loading...
