2.3.9 Printer Connection
:
A user-supplied printer can be connected to the EIA (RS-232C)
Connector on the main unit. The printer is used to print out SMDR
call records and system programming data.
Connect the EIA (RS-232C) connector of the printer to the EIA
Connector.
0
Notes
EIA
~
5 Connector
]i
d
2
i ‘g
k
1-i
Y
‘.> =.
Serial Interface
(RS-232C)
Serial Printer
The
KX-TD1232
is illustrated as a main unit.
Cables must be shielded and the maximum length is 2 m (6.5 feet).
Make cables so that the printer will be connected to the system as
shown in the chart on the following page.
When using special accessories such as cable, the user should use
those specified in this installation manual to comply with the limits
for a class A digital device pursuant to the FCC Rules.
The pin configuration of EIA (RS-232C) Connector is as follows:
(
,l
-d
Pin
NO.
Signal Name
Circuit Type
t-d
EIA CCITT
7 SG Signal Ground
AB 102
8 CD (DCD) Data Carrier Detect CF
109
20 ER (DTR) Data Terminal
CD 108.2
Ready
2-30
Installation
To Next Page
Loading...
