Panasonic KX-TD816 - Caller ID Card Installation

2.4.7
Caller ID Card Installation
._
(2) Installing to the Optional 4-CO Line Unit
The following procedures must be done before installing the 4-CO
Line Unit (KX-TDlgO) to the main unit.
1. Loosen five screws located on the rear of the 4-CO Line Unit.
2. Remove the back plate and take out the P-board.
3. Attach the Caller ID Card to the P-board, fitting the connectors.
4. Put the P-board back into the cabinet and fix the rear plate with
the five screws.
Caller ID Card
Note
For installing the 4-CO Line Unit to the main unit, refer to Section 2.4.4
“Installing Expansion Unit (KX-TD 170 / KX-TD 1 SO).”
Programming References
Section 4, System Programming,
[ 1 lo] Caller ID Code Set
[ 11 l] Caller ID Name Set
[406] Caller ID Assignment
Feature References
Section 3, Features,
Caller ID
2-52
Installation