26
l
starting the
System
for the First Time
KX-TD1232
f-7
(.
J
Dwer
I)
To
Power Indicator
11111111
PI
Notice
l
Switch
System Clear
Switch
Reset Button
AC Outlet
After pressing
the Reset
Button,
slide the System Clear Switch to the
“NORMAL” position at step 6 while the power indicator is flashing
(approximately within 10 seconds). Otherwise, the system does not
start up with the default values.
CAUTION: Once you start up the system and if you turn the power off, do not perform the
above procedures to start the system again. Otherwise, your programmed data is
cleared. To start the system, just turn the Power Switch on.
The power socket wall outlet should be located near this equipment and be easily
accessible.
‘. -
Installation
2-65
To Next Page
Loading...
