Panasonic KX-TDA100 - Page 591

Programming Manual References
3.6 [1-1] Slot—Port Property - Extension Port—Connection Command
Feature Guide References
None
Extension Name
Specifies the name of the extension.
Value Range
Max. 20 characters
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
None
Feature Guide References
None
Outgoing Preferred Line
Selects the line to be seized after going off-hook to make a call.
Value Range
For KX-TDA30:
No Line: No line is seized.
Idle: An idle trunk is seized automatically from the programmed trunk groups.
ICM: An extension line is seized.
F-1–F-36: A trunk programmed for a flexible button (F-1–F-36) is seized. A flexible button customised as a
Single-CO, Group-CO, Loop-CO, or ICD Group button must be selected.
For KX-TDA100/KX-TDA200
/KX-TDA600:
No Line: No line is seized.
Idle: An idle trunk is seized automatically from the programmed trunk groups.
ICM/PDN: An extension line is seized, or, for a PDN extension, an idle PDN button is selected.
F-1–F-36: A trunk programmed for a flexible button (F-1–F-36) is seized. A flexible button customised as a
Single-CO, Group-CO, Loop-CO, or ICD Group button must be selected.
Maintenance Console Location
6.1 [4-1-1] Wired Extension—Extension Settings
Programming Manual References
6.5 [4-1-4] Wired Extension—Flexible Button
PC Programming Manual 591
6.1 [4-1-1] Wired Extension—Extension Settings