2.3 System Data Control
392 Feature Guide
* It is possible to register Quick Dialling numbers that overlap with other registered numbers. This is
used for Automatic Rerouting of Calls via a Private IP Network to Public Trunks.
2. Flexible Numbering (available while busy, DND, or ringback tone is heard)
Feature numbers which are available while busy, DND, or ringback tone is heard can be customised for
easy use. The numbers should be one digit ("0" through "9", " ", or "#") and must not conflict. For
default, refer to the following table:
Data Line Security set/cancel
730
730
Manual Call Waiting for Extension Call off/BSS/OHCA/
Whisper OHCA
731
731
Automatic Call Waiting set/cancel
732
732
Executive Busy Override Deny set/cancel
733
733
Not Ready Mode on/off
735
735
Log-in/Log-out
736
736
Incoming Call Queue Monitor
739
739
Hot Line programme/set/cancel
740
740
Absent Message set/cancel
750
750
BGM set/cancel
751
751
Remote Wake-up Call
76 76
Timed Reminder set/cancel
760
760
Printing Message
761
761
Extension Dial Lock set/cancel
77
77
Time Service Switch
780
780
Remote Extension Dial Lock off
782
782
Remote Extension Dial Lock on
783
783
NDSS Monitor Release
784
784
Trunk Busy Out Clear (not for KX-TDA15)
785
None
Extension Feature Clear
790
790
Extension Personal Identification Number (PIN) set/cancel
799
799
Dial Information (CTI) None None
Other PBX Extension Number (TIE) 1–16 None None
Quick Dialling* None None
Feature Default
Type 1
(with )
Type 2
(without )
To Next Page
Loading...
