Panasonic KX-TDE100 - Automatic Extension Release; Automatic Time Adjustment

1.1.5 Automatic Extension Release
Description
After going off-hook, if an extension user fails to dial any digits within a preprogrammed time period, the user
will hear a reorder tone. This operation applies to intercom calls only.
This feature is also known as Automatic Station Release.
Conditions
• A proprietary telephone (PT)/portable station (PS) user hears a reorder tone for a preprogrammed time
period, and then
the PT/PS returns to idle status automatically. A single line telephone (SLT) user will hear
a reorder tone until he or she goes on-hook.
• This feature works in one of the following cases:
When making an intercom call
a. The first digit is not dialed within a preprogrammed time period.
b. A digit is dialed, but subsequent digits are not dialed within a preprogrammed time period.
PC Programming Manual References
4.5 [2-3] Timers & Counters—Dial / IRNA / Recall / Tone
→
Dial—Extension First Digit
→ Dial—Extension Inter-digit
→ Tone Length—Reorder Tone for PT Handset
→ Tone Length—Reorder Tone for PT Hands-free
1.1.6 Automatic Time Adjustment
Description
The PBX clock can be adjusted automatically in the following two ways:
1. Daylight Saving Time Setting
The start and end dates of Daylight Saving Time can be programmed. The PBX clock will automatically
adjust itself one
hour forward or backward at 2:00 A.M. on the programmed date, if enabled through system
programming. At 2:00 A.M. on the start date, the clock will change to 3:00 A.M., and at 2:00 A.M. on the
end date, the clock will change to 1:00 A.M.
Note
If a Timed Reminder (Remote Wake-up call) is set:
– On the Daylight Saving Time start date, a reminder set for between 2:00 A.M. and 3:00 A.M. will
not ring.
– On the Daylight Saving Time end date, a reminder set for between 1:00 A.M. and 2:00 A.M. will
ring twice.
2. Time Information from Telephone Company
Time information can be received when
– An incoming or outgoing call through an ISDN line is received/made.
– An incoming call through an analog line with Caller ID which includes time information is received.
The PBX clock will be adjusted everyday with the first call after 3:05 AM, if enabled through system
programming.
Document Version 2009-12 Feature Manual 23
1.1.6 Automatic Time Adjustment