3.15 [1-1] Slot—Port Property - Virtual IP Extension
Various settings can be programmed for each virtual IP extension port.
To change the status of virtual IP extension ports, click Command.
IP-PT Registration and De-registration
An IP-PT must be registered to the PBX by programming the PBX and IP-PT before it can be used.
Programming instructions for the PBX are given below.
It is possible to de-register the IP-PT later.
Preparation
Open 3.4 [1-1] Slot—Card Property - IPCMPR, and confirm that the IP addresses of the IPCMPR/
IPCEMPR and DSP cards, subnet mask address, and default gateway address are set.
Registration
Follow the steps below to register the IP-PT.
1. Connect the IP-PT to be registered to the network and, if necessary, the power supply.
2. Click Registration.
A dialogue
box will appear. Non-registered (available) extension numbers and names are displayed on the
left.
3. Highlight numbers and names and click the right arrow to select them for registration. Click Next.
A screen will appear with information on the current IP-PT extension number and name, and index number
for programming.
4. Programme the relevant IP-PT.
5. If the registration is still in progress, the dialogue box will show "Registration Executing".
If the registration is successful, the dialogue box will show "Registration Succeed". Click Close.
Once the IP-PT is successfully registered, the status of the IP-PT will update to show "Registered".
De-registration
Follow the steps below to de-register the IP-PT.
1. Click De-registration.
A dialogue box will appear. Registered extension numbers and names are displayed on the left.
2. Highlight numbers and names and click the right arrow to select them for de-registration. Click Next.
A dialogue box will appear.
3. Click Confirm.
• If the de-registration is successful, the dialogue box will show "
De-registration Succeed
".
• If the de-registration is unsuccessful, the dialogue box will show "De-registration Error".
De-registration will be terminated.
4. Click Close.
If the IP-PT is successfully de-registered, the status of the IP-PT will update to show "None".
Forced De-registration
Follow the steps below to forcibly de-register the IP-PT when normal de-registration has been unsuccessful
or IP address settings have been changed or deleted only on the IP-PT.
1. Click Forced De-registration.
A dialogue box will appear. Registered extension numbers and names are displayed on the left.
PC Programming Manual 183
3.15 [1-1] Slot—Port Property - Virtual IP Extension
To Next Page
Loading...
