No sound in speakerphone/monitor mode with DPT on Panasonic KX-TDE200NZ, why?
If you can't hear anything when using the speakerphone or monitor mode with a DPT on your Panasonic PBX, it's possible that the "HEADSET" mode is selected through Personal Programming under "Handset/Headset Selection". If you're not using a headset, select the "HANDSET" mode through Personal Programming.
Why some Panasonic KX-TDE200NZ PBX features do not work?
If some features on your Panasonic PBX aren't working, it could be because system management has restricted certain features; in this case, consult your manager. It's also possible that the feature numbers have changed, so confirm the revised number and try again.
How to troubleshoot Panasonic PBX telephone?
If your Panasonic PBX telephone isn't working properly, first confirm with your manager that your settings are correct. If the problem continues, it's best to consult your dealer for further assistance.
Why did PC and fax communication fail with Panasonic PBX?
If the PC and fax machine communication failed with your Panasonic PBX, an indication tone may have interrupted communication.
What to do if Panasonic PBX telephone does not respond?
If your Panasonic PBX telephone isn't responding when you press the buttons, it could be because the telephone is locked. Try unlocking your telephone. Another reason might be that your telephone is connected to an eXtra Device Port, which requires system programming. In this case, consult your dealer.
What to do if Panasonic KX-TDE200NZ redialling does not function?
Redialling does not function if the stored number was more than 32 digits or an extension number.
How do I fix 'Cannot register IP-PT' on my Panasonic KX-TDE200NZ PBX?
If you cannot register the IP-PT on your Panasonic PBX, it may be because the necessary network parameters are not set. If you are not using a DHCP server, set the IP address, subnet mask address, and enter the PBX IP address. If necessary, also enter the IP address of the default gateway. When using a DHCP server, enter the PBX IP address.
Why does my Panasonic KX-TDE200NZ PS stay out of service after CS is back in service?
If the PS remains out of service after changing the CS status from Out of Service to In Service on your Panasonic PBX, it may take about 20 seconds for the CS to start up. Wait until the CS starts up completely.
What to do if the LINK indicator of the IP-EXT/IP-GW/IPCMPR does not turn on for Panasonic PBX?
If the LINK indicator on your Panasonic PBX for the IP-EXT, IP-GW, or IPCMPR isn't lighting up, it could point to a few issues. The IP-EXT or IP-GW card might be malfunctioning, requiring a replacement. Similarly, the IPCMPR card could be faulty and need replacing. A poor connection is another possible cause; ensure you're using an 8-pin twisted pair cable, that no CAT 5 cables exceed 100 meters in length, and that a straight cable is used for connecting to a switching hub. Finally, a network malfunction could be the problem, so verify that all network devices are switched on.
What to do if proprietary telephone operations do not work even after following the manual instructions on Panasonic PBX?
If none of the operations work when using a proprietary telephone on your Panasonic PBX, even after following the manual instructions, the Intercom line was not seized. If the setting has been changed, press the INTERCOM or PDN button after going off-hook and follow the instructions. Alternatively, the seized line, when going off-hook, may have been changed by personal setting.
To Next Page
General