• *
If you do not enter an entry code when making the conference group call, extensions/outside
telephones can join the conversation without needing to enter an entry code.
• Entry codes can consist of the digits "0" through "9". When "
" is used for an entry code, no
one can join a conversation that is already in progress. For details, refer to " Join After
Time Out".
• A conversation can be established with a maximum of 8 parties
(including the caller).
• With PTs and KX-TCA185/KX-TCA285/KX-TCA385/KX-WT125/KX-WT126 PSs, a
conference group call can be automatically answered without going off-hook. This mode is
selected through system programming.
• If using an SLT, the caller can only originate a conference group call and cannot control the
called parties’ call status manually.
For a caller
To end a conversation with a specific party
PT/PS
To end a conversation with a specific party
During a conversation
(DSS)
Press DSS.
To end a conversation with the party who
joined the conversation last
Press TRANSFER.
To disconnect the party who joined the
conversation last from the conference group call
Press FLASH/RECALL.
TRANSFE R
FLASH/
RECALL
• In this case, the FLASH/RECALL button must be set to Flash/Recall mode through system
programming.
Broadcast Mode
If
this mode is selected through system programming, the caller can call multiple parties in a conference group,
make a voice announcement, and then establish a multiple party conversation with the called parties. This
conversation will be heard by all called parties. Called parties can listen to the announcement simply by going
off-hook. They can send a notification tone if they want to join the conversation.
62 Operating Manual Document Version 2013-05
1.3.17 Conference Group Call
To Next Page
Loading...
