To Next PageTo Next Page
How to fix noise on external paging for Panasonic Telephone?
If you are experiencing noise on external paging with your Panasonic Telephone, use a shielded cable as the connection wire between the PBX and amplifier. A short shielded cable is recommended.
Why is redialling not working on my Panasonic Telephone?
Redialling does not function if the stored number was more than 32 digits or an extension number.
What to do if the Panasonic Telephone does not respond when buttons are pressed?
If your Panasonic Telephone isn't responding when you press the buttons, it might be locked. Try unlocking it. Another possibility is that your telephone is connected to an eXtra Device Port, in which case system programming is required, and you should consult your dealer.
What to do if parallel single line telephones do not ring on Panasonic KX-TDE600?
If the parallel single line telephones do not ring on your Panasonic PBX, the "No ring" option may be selected. Change the setting to ring.
Why is the line disconnected while talking to an outside party on Panasonic KX-TDE600 PBX?
If the line is disconnected while you are talking to an outside party on your Panasonic PBX, the time limit may have run out. Consult your dealer to extend the time limit, if necessary.
What to do if proprietary telephone operations do not work even after following the manual instructions on Panasonic KX-TDE600 PBX?
If none of the operations work when using a proprietary telephone on your Panasonic PBX, even after following the manual instructions, the Intercom line was not seized. If the setting has been changed, press the INTERCOM or PDN button after going off-hook and follow the instructions. Alternatively, the seized line, when going off-hook, may have been changed by personal setting.
What to do if Panasonic KX-TDE600 PBX telephone does not work with personal settings?
If your Panasonic PBX telephone does not work using the personal settings or with other settings (One-touch dialling, forwarding destination, etc.), the extension line may have been changed. Clear the settings and then programme your desired settings again.
How to fix a Panasonic KX-TDE600 display that is not shown well?
If the display is not shown well on your Panasonic PBX, change the Display contrast level.
Why can't I send a call waiting tone on my Panasonic PBX?
If you cannot send a call waiting tone to the dialed extension on your Panasonic PBX, it could be because the other party has not set the Call Waiting feature. It is also possible that the other party has set Data Line Security.
Why is the line disconnected while talking to an outside party on Panasonic Telephone?
If the line is disconnected while talking to an outside party on your Panasonic Telephone, the time limit may have run out. Consult your dealer to extend the time limit, if necessary.
General| SIP trunking | Yes |
|---|---|
| SIP extensions | 128 |
| Number of extensions | 960 |
| Number of DECT wireless handsets | 512 |
Weight and Dimensions| Weight | 16000 g |
|---|---|
| Dimensions (WxDxH) | 415 x 270 x 430 mm |
Indicates potential for severe injury or death due to misuse.
Alerts to potential for minor injury or property damage due to misuse.
Outlines essential safety requirements for telephone equipment installation and use.
