Panasonic KX-TEB308 - Wall Mounting; Mounting on a Wooden Wall

2.2 Installing the Advanced Hybrid System
34 Installation Manual
2.2.7 Wall Mounting
The PBX is designed for wall mounting only. The wall where the PBX is to be mounted must be able
to support the weight of the PBX. When wall mounting the main unit, use either the included screws,
or screws of the same size.
Mounting on a Wooden Wall
The included screws may be used when mounting the main unit on a wooden wall.
1. Place the template (found on the last page of this manual) on the wall to mark the 3 screw
positions.
Note
When you print out the template, the distance on the paper output may deviate slightly from the
indicated measurement. In this case, use the indicated measurement.
2. Fit the washers on the screws, and drive the screws into the wall.
3. Affix the PBX to the screw heads.
232 mm
120 mm
Template
Washer
Drive the screw
to this point.