Panasonic KX-TEM824 - VM 1 APT Port [130]; VM 2 APT Port [131]; SLT Ring;Silence Ratio [142]

3.3 PT Programming
206 Feature Guide
Note
This programme selects the ringback tone pattern for outgoing intercom calls and for incoming outside
(CO) line calls (including a DISA call).
Feature & Programming References
1.5.1.1 Intercom Call
1.15.6 Direct Inward System Access (DISA)
4.2.1 Tones/Ring Tones
VM 1 APT Port [130]
Notes
• To change the current setting (other than "Disable"), select "Disable", then select the desired
setting.
• This programme is not available when "Enable" is selected in DTMF Integration [103].
Feature & Programming References
1.19.1 Voice Mail APT Integration
VM 2 APT Port [131]
Notes
• To change the current setting (other than "Disable"), select "Disable", then select the desired
setting.
• This programme is not available when "Enable" is selected in DTMF Integration [103].
Feature & Programming References
1.19.1 Voice Mail APT Integration
SLT Ring/Silence Ratio [142]
Note
This programme selects the ratio between the bell signals of an SLT (a set of bell-on and bell-off).
1 3 0
NEXT SELECT STORE END
(Port7/Port7 & 8/
Disable)
1 3 1
NEXT SELECT STORE END
(Port15/
Port15 & 16/
Disable)
1 4 2
NEXT SELECT STORE END
(1:2/1:3/1:4)
[On:Off]