6
Preparation
Location
For maximum distance and noise-free
operation, place your base unit:
− Away from electrical appliances such as
TVs, radios, personal computers or other
phones.
− In a convenient, high and central location.
Battery installation
Insert the batteries negative (T) terminal
first. Close the handset cover.
Note:
L Use only the included rechargeable
batteries (page 3, 4).
Turning the power on/off
Power on
Press {ih} for about 1 second.
Power off
Press {ih} for about 2 seconds.
Battery charge
Place the handset on the base unit or
charger for about 7 hours before initial
use.
Battery strength
Panasonic Ni-MH battery performance
Note:
L It is normal for batteries not to reach full
capacity at the initial charge. Maximum
battery performance is reached after a few
complete cycles of charge/discharge
(use).
L Actual battery performance depends on a
combination of how often the handset is in
use and how often it is not in use
(standby).
L Even after the handset is fully charged,
the handset can be left on the base unit or
charger without any ill effect on the
batteries.
L The battery strength may not be displayed
correctly after you replace the batteries. In
this case, place the handset on the base
unit or charger and charge for at least 7
hours.
Battery icon Battery strength
054 Fully charged.
5 High
6 Medium
7 Low
074 Needs to be charged.
Operation Operating time
In continuous use 10 hours max.
In continuous standby
mode
120 hours max.
TG1100_1102FX(e-e).book Page 6 Wednesday, February 15, 2006 11:42 AM
To Next Page
Loading...
