Panasonic KX-TG1381 - Page 19

19
KX-TG1381HKH/KX-TG1381HKV/KX-TG1381HKW/KX-TG1382HKH/KX-TGA131HMH/KX-TGA131HMV/KX-TGA131HMW
Frequency Used Items (Base Unit)
ex.)
Note:
*: When you enter the address, please refer to the table below.
(*1)
(*2)
Items (*2) Address Default Data New Data Remarks
C-ID (FSK) sensi-
tivity
0A1D~0A1E 00 28 (3dB up)
00 A4
(6dB up)
00 E7
When hex changes from “006D” to “00A4” or “00E7”,
gain increases by 3dB or 6dB.
C-ID (DTMF) sen-
sitivity
0A 2D 34 (3dB up)
38
(6dB up)
3C
When hex changes from “34” to “38” or “3C”, gain
increases by 3dB or 6dB.
Frequency 00 00~00 01 Given value - - Use these items in a READ-ONLY mode to confirm
the contents. Careless rewriting may cause serious
damage to the computer system.
ID 00 20~00 24 Given value - -
Bell length 0F 12 3C (6 sec) (*1) 1E (3sec) 14 (2sec) This is time until bell stops ringing. (Unit: 100ms)
PULSE Dial speed
(10PPS -> 20PPS)
0F 06 21 (33 msec) (*1) 14 (20 msec) - This is pulse make time. (Unit:1 ms)
0F 07 43 (67 msec) (*1) 1E (30 msec) - This is pulse break time. (Unit:1 ms)
0F 0A 4A (740 msec)
(*1)
2C (440 msec) - This is inter-digit time in pulse mode.
(Unit:10 ms)
Desired Number (hex) Input Keys Desired Number (hex) Input Keys
00 A[R] + 0
11 B[R] + 1
.. C[R] + 2
.. D[R] + 3
.. E[R] + 4
99 F[R] + 5
Bell length 3C(hex) = 60(dec) → 60 × 100msec = 6000msec (6sec)
PULSE Dial speed
(10PPS -> 20PPS)
21 (hex) = 33 (dec) → 33 × 1 msec = 33 msec
43 (hex) = 67 (dec) → 67 × 1 msec = 67 msec
4A (hex) = 74 (dec) → 74 × 10 msec = 740 msec
Items Description
C-ID (FSK) sensitivity FSKGain_shiftgain
C-ID (DTMF) sensitivity Foutgains:HPFilter Foutgains
Frequency Setting value of FREQ_TRIM_REG
ID ID
Bell length Time until it stops bell.