Panasonic KX-TG2512CX - Recording Your Greeting Message; Listening to Messages

Answering System
24
Recording your greeting
message
You can record your own greeting
message.
1 {j/OK}
2 {V}/{^}: “Answer System” i
{j/OK}
3 {V}/{^}: “Greeting” i {j/OK}
4 {V}/{^}: “Start REC” i
{j/OK}
5 {V}/{^}: “Yes” i {j/OK}
6 After a beep sounds, hold the
handset about 20 cm away and
speak clearly into the microphone (2
minutes max.).
7 Press {j/OK} to stop recording.
8 {ic}
Using a pre-recorded greeting
message
The unit provides 2 pre-recorded
greeting messages:
– If you erase or do not record your own
greeting message, the unit plays a
pre-recorded greeting asking callers
to leave a message.
– If the message recording time (page
28) is set to “Greeting Only”,
callers’ messages are not recorded
and the unit plays a different pre-
recorded greeting message asking
callers to call again.
Resetting to a pre-recorded greeting
message
If you want to use a pre-recorded
greeting message once you record your
own greeting message, you need to
erase your own greeting message.
1 {j/OK}
2 {V}/{^}: “Answer System” i
{j/OK}
3 {V}/{^}: “Greeting” i {j/OK}
4 {V}/{^}: “Default” i {j/OK}
2 times
5 {ic}
Playing back the greeting
message
1
{j/OK}
2 {V}/{^}: “Answer System” i
{j/OK}
3 {V}/{^}: “Greeting” i {j/OK}
4 {V}/{^}: “Play Greeting” i
{j/OK}
5 {ic}
Listening to messages
When new messages have been
recorded, “Messages” is displayed on
the handset with the total number of new
messages.
1 {j/OK}
2 {V}/{^}: “Answer System” i
{j/OK}
3 {V}/{^}: Select “Play New Msg.”
or “Play All Msg.”. i {j/OK}
4 When finished, press {ic}.
Note:
L To switch to the receiver, press {C}.
L If “Messages Full” is shown on the
display, “Messages” and the total
number of new messages are not
displayed.
TG2511_2521CX(e-e).book Page 24 Thursday, March 11, 2010 10:34 AM