Answering System
26
unauthorised parties from listening to
your messages remotely.
Important:
L In order to operate the answering
system remotely, you must first set a
remote access code.
1 {j/OK}
2 {V}/{^}: “Answer System” i
{j/OK}
3 {V}/{^}: “Settings” i {j/OK}
4 {V}/{^}: “Remote Code” i
{j/OK}
5 To turn on remote operation, enter
the desired 3-digit remote access
code.
6 {j/OK} i {ic}
Deactivating remote operation
Press {*} in step 5 on “Remote access
code”, page 25.
L The entered remote access code is
deleted.
Using the answering system
remotely
1
Dial your phone number from a
touch-tone phone.
2 After the greeting message starts,
enter your remote access code.
L The unit announces the number of
new messages.
3 Follow the voice guidance prompts
as necessary or control the unit
using remote commands (page 26).
4 When finished, hang up.
Note:
L You can also leave a message just as
any outside caller can. After the
greeting message starts, press {*} to
skip the greeting message and record
your message after the beep.
Voice guidance
During remote operation, the unit’s voice
guidance starts and prompts you to
press {1} to perform a specific
operation, or press {2} to listen to more
available operations.
Note:
L If you do not press any dial keys within
10 seconds after a voice guidance
prompt, the unit disconnects your call.
Remote commands
You can press dial keys to access
certain answering system functions
without waiting for the voice guidance to
prompt you.
*1 If pressed within the first 5 seconds of
a message, the previous message is
played.
Key Operation
{1} Repeat message
(during playback)
*1
{2} Skip message
(during playback)
{4} Play new messages
{5} Play all messages
{6} Play greeting message
{7} Record greeting message
{9} Stop recording
Stop playback
{0} Turn answering system off
{*}{4} Erase currently playing
message
{*}{5} Erase all messages
{*}{6} Reset to a pre-recorded
greeting message (during
greeting message
playback)
{*}{#} End remote operation
(or hang up)
TG2511_2521CX(e-e).book Page 26 Thursday, March 11, 2010 10:34 AM
To Next Page
Loading...
