“
85
For assistance, please call: 1-800-211-PANA(7262)
Useful Information
Problem
You cannot operate the
answering system from a
touch tone phone.
You cannot operate the
answering system with the
cordless handset.
While recording a greeting
message, the unit starts to
ring and stops recording.
During playback, the unit
starts to ring and stops
playback.
The base unit does not
display the name and/or
number of the caller whose
message is being played.
Cause and Remedy
≥Make sure you enter the correct remote
code.
≥The answering system may not respond
if the tones are too short to activate the
unit. Press each button firmly.
≥The answering system is off. Turn it on
(p. 71).
≥Someone is operating the answering
system.
≥You are too far from the base unit.
Move closer to the base unit.
≥The unit is recording a message.
To answer the call, press .
≥To answer the call, press
(DIGITAL\SP-PHONE), lift the handset or
press . Start again from the
beginning after hanging up.
≥To answer the call, press
(DIGITAL\SP-PHONE), lift the handset or
press .
≥If the caller is not stored in the Caller
List, the base unit will not display the
caller’s information.
Problem
The unit does not work.
Cause and Remedy
≥Check the settings (p. 10–16).
≥Charge the battery fully (p. 11).
≥Clean the charge contacts and charge
again (p. 12).
≥Install the battery properly (p. 77).
≥
Place the cordless handset on the charger
and unplug the AC adaptor of the base
unit to reset. Plug in, and try again.
General
To Next Page
Loading...
