Useful InformationAnswering SystemTelephone System
11
Displays
Preparation
Base unit
1“ ” indicates the line 1 ringer on the base unit is off
(p. 27).
“ ” indicates the line 2 ringer on the base unit is off
(p. 27).
2“ ” flashes when no new messages can be
recorded. Erase unnecessary messages (p. 78).
3 “E” flashes until you set the date and time, and flashes after a power failure. If
it is flashing, set the date and time (p. 22).
4 Message counter shows:
— the number of recorded messages (p. 74). If the recording time is set to
“Greeting only”, “ ” will be displayed for a few seconds when you turn the
Answering System on (p. 72).
— the selected volume level while you are adjusting the speaker volume
(p. 31, 39).
—
“ ” when
[PROGRAM]
is pressed to store a phone number (p. 55).
— “ ” when your greeting message or memo message was not recorded
correctly (p. 31, 79).
5 “ ” and/or “ ” will be displayed when selecting the line(s)
a) to record the greeting message (p. 30);
b) to turn the Answering System on (p. 72);
c) to play back messages (p. 31, 74);
d) to erase messages (p. 78);
e) to change the ringer volume or tone (p. 27, 29).
“ ” and/or “ ” will flash when
a) the Answering System is answering a call on the line (p. 72);
b) a message on the line is played (p. 74).
F
ULL
L
2
L
1
LINE
1
LINE
2
12 3 4
5
L 1
L 2
FULL
LINE 1 LINE 2
LINE 1 LINE 2
TG6500C_Preparation.fm Page 11 Thursday, September 30, 2004 4:54 PM
To Next Page
Loading...
