Panasonic KX-TG6500C - Intercom; Making Intercom Calls from Handset; Making Intercom Calls from Base Unit

56
Intercom
Intercom calls can be made between a handset and the base unit, and between 2
handsets (when the system has 2 or more handsets, p. 3). You can page all
handsets at once from the base unit, and announce the page to all handsets (Voice
Paging, p. 58).
Page the desired unit(s) by entering the extension number, shown in the top right of
each handset’s display. The base unit’s extension number is 0.
Making Intercom Calls
From
From
Using this feature, you can also locate a misplaced handset.
1 Press [HOLD/INTERCOM].
2 To page the base unit, press [0].
To page another handset, press its extension
number ([1] to [4]).
• The paged unit will ring for 1 minute.
• To stop paging, press [OFF].
3 When the paged party answers, begin
speaking.
• You can switch to the speaker by pressing [s].
To switch back to the receiver, press [C].
4 To disconnect the intercom, press [OFF].
1 Press [LOCATOR/INTERCOM/TRANSFER].
• The LOCATOR/INTERCOM/TRANSFER and SP-PHONE indicators light.
2 To page all handsets, press [0] .
To page a specific handset, press its extension number
[1] ( ) to [4] ().
• The handset(s) will ring for 1 minute.
•
To stop paging, press [SP-PHONE] or [LOCATOR/INTERCOM/TRANSFER] .
3 When the paged party answers, speak into the MIC.
4 To disconnect the intercom, press [SP-PHONE] or [LOCATOR/
INTERCOM/TRANSFER].
• The indicator lights go out.
Handset
Press extension#
to call
1-4=Handset
0=Base
Calling Base
e.g. Calling Base unit
Calling HS[2]
e.g. Calling Handset 2
Intercom
00-00-05
D01
e.g. Intercom between
Handset 1 & Base uni
t
Base Unit
TG6500C_CordlessTel2.fm Page 56 Thursday, September 30, 2004 4:56 PM