Useful Information
42
Wall mounting
The base unit can be mounted on a wall
by revolving the bracket to “WALL”
position (default: “DESK” stand
position).
Note:
L Make sure that the wall is strong
enough to support the weight of the
unit.
L Drive the screws (not supplied) into
the wall.
Base unit
1
Turn the bracket 180 degrees
counterclockwise in the “WALL”
direction until a click is heard.
L The bracket cannot be removed.
Do not turn the bracket more than
180 degrees.
2 Tuck in the telephone line cord (A).
Connect the AC adaptor cord and
telephone line cord (B).
3 Mount the unit on a wall then slide
down to secure in place.
To stand on a desk
Turn the bracket 180 degrees clockwise
from the “WALL” position to the “DESK”
direction until a click is heard.
Charger
Bottom
A
B
Hook
(100-240 V AC,
50/60 Hz)
83 mm
Screws
To single-line
telephone jac
To Next Page
Loading...
