Initial settings
n Direct command code:
Programmable settings can be accessed
by pressing MMENUN, # and then the
corresponding code on the dial keypad
(page 34).
Example: Press MMENUN#101.
n Symbol meaning:
Symbol Meaning
Example:
MbN: “Off”
Press MCN or MDN to select
the words in quotations.
Important:
R When you install the batteries for the first
time, the handset may prompt you to set
display language and date and time.
Perform step 2 in "Display language",
page 17, and then press MSELECTN.
Continue from step 2 in “Date and
time”, page 17.
Display language
You can select either “English” or
“Français” as the display language. The
default setting is “English”.
1 MMENUN#110
2 MbN: Select the desired setting. a
MSAVEN
3 MOFFN
Date and time
1 MMENUN#101
2 Enter the current month, date, and year
by selecting 2 digits for each.
Example: July 15, 2012
07 15 12
3 MOKN
4 Enter the current hour and minute
(12-hour clock format) by selecting 2
digits for each.
Example: 9:30
09 30
5 MAM/PMN: Select “AM” or “PM”.
6 MSAVEN a MOFFN
Note:
R When English is selected as the display
language, 12-hour clock format is used.
When French is selected, 24-hour clock
format is used.
R The date and time may be incorrect after a
power failure. In this case, set the date and
time again.
Voice guidance language
You can select either “English” or
“Français” as the voice guidance language
of the Talking Call Display and answering
system. The default setting is “English”.
1 MMENUN#112
2 MbN: Select the desired setting. a
MSAVEN
3 MOFFN
Dialing mode
If you cannot make calls, change this setting
according to your telephone line service. The
default setting is “Tone”.
“Tone”: For tone dial service.
“Pulse”: For rotary/pulse dial service.
1 MMENUN#120
2 MbN: Select the desired setting.
3 MSAVEN a MOFFN
17
Getting Started
To Next Page
Loading...
