Menu list
Problem Cause/solution
The display is in a language I
cannot read.
R Change the display language (page 16).
I cannot register a handset to a
base unit.
R The maximum number of handsets (6) is already
registered to the base unit. Cancel unused handset
registrations from the base unit (page 41).
Battery recharge
Problem Cause/solution
The handset beeps and/or
flashes.
R Battery charge is low. Fully charge the batteries (page 12).
I fully charged the batteries, but
– still flashes,
–
is displayed, or
– the operating time seems to
be shorter.
R Clean the battery ends ( , ) and the charge contacts
with a dry cloth and charge again.
R It is time to replace the batteries (page 11).
Making/answering calls, intercom
Problem Cause/solution
is displayed.
R The handset is too far from the base unit. Move closer.
R The base unit’s AC adaptor is not properly connected.
Reconnect AC adaptor to the base unit.
R The handset is not registered to the base unit. Register it
(page 41).
Noise is heard, sound cuts in
and out.
R You are using the handset or base unit in an area with
high electrical interference. Re-position the base unit and
use the handset away from sources of interference.
R Move closer to the base unit.
R If you use a DSL/ADSL service, we recommend
connecting a DSL/ADSL filter between the base unit and
the telephone line jack. Contact your DSL/ADSL provider
for details.
The handset or base unit does
not ring.
R The ringer volume for landline is turned off. Adjust the
ringer volume (page 22, 36).
R The ringer volume for cellular line is turned off. Adjust the
ringer volume (page 22, 34).
R The unit which is not selected to ring for cellular calls
does not ring. To change the selection, see page 18.
R Silent mode is turned on. Turn it off (page 40).
R The ringer volume is turned off by pressing and holding
0 ( ). Press and hold 0 ( ) again to turn it on
(page 22).
For assistance, please visit http://shop.panasonic.com/support
63
Useful Information
To Next Page
Loading...
