– 6 –
Trademarks
LThe Bluetooth
®
word mark and logos are owned by the Bluetooth SIG, Inc. and any use of such marks by
Panasonic Corporation is under license. Other trademarks and trade names are those of their respective
owners.
Using a Bluetooth wireless headset (optional)
Operating a Bluetooth wireless headset
NMaking calls
After dialing the phone number using the base unit, you can operate the call with your headset.
Refer to your headset operating instructions for further details.
NAnswering calls
Refer to your headset operating instructions for further details.
NSwitching a call between the headset and base unit speakerphone
To switch to the base unit speakerphone, press {s}.
To return to the headset, press {W}.
NAdjusting the receiver volume
Press {^} or {V} repeatedly while talking on the headset.
LTo adjust the volume using the headset, refer to your headset operating instructions.
Quick troubleshooting
Using Bluetooth
®
devices (Base unit only)
“No link to base. Reconnect AC adaptor.”
Handset shows:
Place the handset on the base unit, then check if “Charging” is
displayed.
“Charging” is not displayed.
“Charging” is
displayed.
Unplug and then plug AC adaptor properly to
both the base unit and AC outlet.
Unplug the AC adaptor of the base unit and remove the batteries from the
handset, then plug in the AC adaptor and insert the batteries into the handset
again. Try to re-register the handset.
Lift the handset, then try again.
If handset still shows the same message, try to
re-register the handset.
“Charging” is
still not displayed.
Re-registration failed.
Re-registration failed.
“Charging” is
displayed, now.
Your telephone may need service.
Please visit http://www.panasonic.com/help for further troubleshooting.
TG938x_QG(e).fm Page 6 Wednesday, July 1, 2009 3:22 PM
To Next Page
Loading...
