Feature Code Setting
System
*1
Pag
e
Answer on
M3N M2N M7N –
60
Answer off
M3N M2N M8N –
60
Voice prompt
(C
hange language)
M1N M1N M2N M1N: <English>
M2N: Español
18
Message alert
M3N M4N M0N M1N:
<O
n> M0N: Off – 66
*1 If “System” column is checked, you do not need to program the same item using
an
other handset.
*2 This tone lets you know when you receive an outside call while you are on
another line or an intercom call. If you select “On”, the tone sounds 2 times.
*3 Turn this feature off if you prefer not to hear key tones while you are dialing or
pressing any keys, including confirmation tones and error tones.
*4 If you subscribe to a Caller ID service and want to view the caller’s information
after lifting up the handset to answer a call, turn off this feature.
*5 The handset can display the Internet address where you can download the
operating instructions or get further information for this product, using your
computer.
*6
When the ringer volume is turned off on the handset,
is displayed followed by
th
e line indication (1, 2: cellular line, L: landline). If all line ringer volumes are
turned off, “
” is displayed without the line indications. The handset does not
ri
ng for outside calls. However even when the ringer volume is set to off, the
handset still rings for alarm (page 50), intercom calls, and paging (page 69).
*7 Even when the ringer volume is set to off, the base unit still rings for intercom
calls.
*8 If you select one of the melody ringer tones, the ringer tone continues to play for
several seconds even if the caller has already hung up. You may either hear a
dial tone or no one on the line when you answer the call.
*9 The preset melodies in this product are used with permission of © 2009
Copyrights Vision Inc.
*10 After the Bluetooth device is registered, the device name is displayed.
*11 This feature allows the unit to automatically adjust the date and time each time
caller information including date and time is received.
To turn this feature on, select “Caller ID auto”. To turn this feature off,
select “Manual”. (Caller ID subscribers only)
To use this feature, set the date and time first (page 18).
*12 If you subscribe to a distinctive ring service (such as IDENTA-RING), select a
tone (tone 1 to 5). If you select a melody, you cannot distinguish lines by their
ringers.
*13 The flash time depends on your telephone exchange or host PBX. Contact your
PBX supplier if necessary. The setting should stay at “700 ms” unless pressing
MFLASHN fails to pick up the waiting call.
*14 Generally, the line mode setting should not be changed. This setting
automatically maintains receiver volume at the proper level depending on the
48
For assistance, please visit http://www.panasonic.com/help
Programming
To Next Page
Loading...
