Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
9
Preparation
Registering the handset to the KX-TG7100/KX-TG7120
base unit
Ensure that the handset is switched on. If it is not on, press and hold
{ih}
for few seconds to turn the handset on.
1
Lift the handset and press
{ih}
to put the handset in standby mode.
2
Press and hold
{x}
on the base unit for about 3 seconds, until the
registration tone sounds.
3
Place the handset on the base unit. The registration tone continues to
sound. With the handset still on the base unit, wait until a confirmation
tone sounds and
w
stops flashing.
Note:
•
If an error tone sounds, or if
w
is still flashing, register the handset
manually. (See manual registration in the KX-TG7100/KX-TG7120
operating instructions.)
•
If all registered handsets start ringing in step 2, press
{x}
to stop. Start
again from step 1.
•
Charge the batteries for about 7 hours before initial use.
•
The KX-TG7100 does not feature an answering system.
•
Answering system features are available only when this handset is
registered to the KX-TG7120.
TGA711E(e).fm Page 9 Thursday, March 9, 2006 11:51 AM
To Next Page
Loading...
