Error messages
Display message Cause/solution
Ask phone
company for
VM access #
R You have not stored the voicemail access number.
Store the number (page 83).
Main unit
no power
or
No link. Re-
connect base
AC adaptor.
or
No link.
R Confirm the base unit’s AC adaptor is connected to
the unit and the power outlet correctly.
R The handset has lost communication with the base
unit. Move closer to the base unit and try again.
R Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R The handset’s registration may have been canceled.
Re-register the handset (page 66).
R When “No link.” is displayed during a power
failure, place a handset on the base unit to supply
power to the base unit.
Busy
R No cellular phone is paired to the base unit. Pair a
cellular phone (page 20).
R The called unit is in use.
R Other units are in use and the system is busy. Try
again later.
R The handset you are using is too far from the base
unit. Move closer and try again.
R The automated call block function is in operation. Try
again later.
R One of the units is screening for telemarketing calls.
Try again later.
R One of the units is recording a conversation with an
outside caller. Try again later.
R Only 1 Bluetooth device can be used with the unit at
a time. Try again later.
R The voice recognition feature could not be activated.
Try again later.
Check tel line
R The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 12).
R If you do not connect the telephone line cord and use
only cellular lines, set the cellular line only mode
(page 22).
Checking
R The automated call block function is in operation. Try
again later.
86
For assistance, please visit http://shop.panasonic.com/support
Useful Information
To Next Page
Loading...
