Panasonic KX-TGH262B - Test Modes: Engineering Mode Procedures; Base Unit Engineering Mode Entry and Parameters

26
KX-TGH260/KX-TGH262/KX-TGH263/KX-TGH264/KX-TGHA20/KX-TGA20
8 Test Mode
8.1. Engineering Mode
8.1.1. Base Unit
1). Press {MENU}.
2). Select "Settings" using or
then press
{SELECT} or {>}.
H/S key operation
H/S LCD
{^}
3). Enter "7", "2", "6", "2", "7", "6", "6", "4".
Note: 7262 7664 = PANA SONI
(see letters printed on dial keys)
5). Enter "
ە ", " ە ", " ە ", " ە " (Address). (*1)
6). Enter "
㸨 ", " 㸨 " (New Data). (*1)
4). Select "Write EEP" using or
then press
{SELECT} or {>}.
{^} {V}
Default Data
Select "Set tel line" using or
then press
{SELECT} or {>}.(*)
{^} {V}
Service Mode
Read EEP
Write EEP
Set Addr.:
BACK
SELECT
CLEAR
OK
{V}
{OFF}
{FLASH}
{CALL WAIT}
Dial keypad
This pictured model is KX-TGH260
Important:
Make sure the address on LCD is correct when entering new data. Otherwise, you may ruin the unit.
Make sure the link between Base and Handset before that. Then in case using not original Handset,
Note: Refer to Registering a Handset to a Base Unit in the Operating Instructions.
you need to deregister Handset.