Panasonic KX-TS600W - Voice Mail (VM) Tone

Settings
16
For assistance, please visit http://www.panasonic.com/phonehelp
Voice Mail (VM) Tone
If your voice mail service sends a voice mail tone after a new message has
finished recording, set to “ON”. “ ” icon will flash on the display if a
message was recorded in your mailbox. You will hear a series of voice mail
tones then a dial tone after lifting the handset.
(Contact your service provider about your service.)
Set to “OFF” when:
— you subscribe the FSK voice mail service.
— you do not subscribe to a voice mail service.
— your voice mail service does not send a voice mail tone, or
— the unit is connected to PBX.
Your phone comes from factory set to “ON”.
1
Press [[FUNCTION/EDIT]].
2
Scroll to “Program ?” by pressing []
or [], and press [OK] (Yes key).
3
Scroll to “VM tone detect ?” by
pressing [] or [].
4
Press [OK] (Yes key).
5
Select “Off” or “On” by pressing [] or
[]. (Ex. “On” is selected.)
6
Press [OK] (Save key).
• A long beep sounds.
• The display will return to step 3. To exit
the programming mode, press [EXIT] or
wait for 60 seconds.
VM tone detect ?
34 [OK]=Yes
VM tone detect
:On
34 [OK]=Save
TS600W.book Page 16 Friday, October 28, 2005 2:10 PM