Speed Dialer
20
7
Press
[ENTER]
.
If the memory station number
selected manually is occupied, the
display on the right will be shown.
To overwrite, press
[ENTER]
.
To select other empty memory station
number, press
[]
, enter an empty
memory station number using the dialing
buttons, or pressing
[]
or
[]
, then
press
[ENTER]
.
• To continue storing other items, repeat from step 2.
• The display will return to step 1. To exit the programming mode, press
[FUNCTION/EXIT]
or wait for 60 seconds.
• If the display shows “
MEMORY IS FULL
” in step 2, press
[FUNCTION/EXIT]
to
exit. To erase other stored items from the Speed Dial List, see page 24.
• You can exit the programming mode any time by pressing
[FUNCTION/EXIT]
.
• If a pause is required for dialing, press
[REDIAL/PAUSE]
where needed. If
required, you can also store
[FLASH]
in a phone number. Pressing
[REDIAL/PAUSE]
or
[FLASH]
counts as one digit (p. 25, 26).
• When using the Dial Lock (p. 28) or Call Restriction feature (p. 29), you cannot
store the phone number in the Speed Dial List (
#01
to
#03
).
STORED
OVERWRITE ?
#
04
<
<
<
To Next Page
Loading...
