Special Features
28
Dial Lock
You can prevent others from making a call to any number except dialing by
the Speed Dial List (#01, #02 and #03). Once you locked the dialing
buttons, even emergency numbers cannot be dialed. Only incoming calls
are accepted until the dial lock is canceled.
To set the dial lock
1
Press
[DIAL LOCK]
.
•“ ” flashes on the display.
2
Enter the password (p. 27).
3
Press
[ENTER]
.
•“ ” displays.
• If the wrong password was entered,
“
ERROR
” will be displayed, then “– – – –” will
be displayed. Enter the correct password.
To cancel the dial lock
Follow above steps 1 through 3. In step 3, “” will go out.
Before using the Dial Lock or Call Restriction feature (p. 29), we recommend
storing emergency numbers in the memory of
the
Speed Dial List (#01, #02 or
#03) (p. 19). Even if the dialing buttons are locked or the stored numbers are
restricted, the numbers stored in these buttons can be dialed.
If the dial buttons are pressed after lifting the handset, “
DIAL LOCKED
” will be
displayed.
You can use the following features while the dialing buttons are locked.
• Dialing a number you programmed into the memory of
the
Speed Dial List
(#01, #02 and #03) (p. 22)
• Selecting the ringer volume (p. 11)
• Adjusting the handset volume (p. 12)
• Answering the second call by pressing
[FLASH]
(p. 26)
• Programming [except storing/erasing Speed Dial List (#01, #02 and #03)]
• Finding an item in the following:
—Caller list (p. 14)
—Speed dial list (p. 22)
—Redial list (p. 12)
ENTER PASSWORD
:
To Next Page
Loading...
