32
Problem Cause and Remedy
The unit does not work. • Check the settings (p. 6–11).
• Remove the batteries and reinstall them
to reset the unit.
The unit does not ring. • The ringer selector is set to OFF. Set to
HIGH or LOW (p. 11).
The display is blank. • Install new batteries (p. 31).
You cannot dial. • Check that the dialing mode selection is
correct (p. 10).
• Dial lock mode is set. To cancel the
mode, see page 28.
• The dialed number is restricted. To
cancel, see page 29.
You cannot program items
such as the dialing mode.
• Programming is not possible when the
handset is off the cradle.
• Do not pause for over 60 seconds while
programming.
You cannot store a name
and phone number in
memory.
• When using the Dial Lock (p. 28) or Call
Restriction feature (p. 29), you cannot
store a phone number in the Speed Dial
List (#01, #02 and #03).
• If “
MEMORY IS FULL
” is displayed,
erase other stored items from the Speed
Dial List (p. 24).
• Programming is not possible when the
handset is off the cradle.
• Check that the batteries are installed in
the unit and that the battery power is not
low.
• Do not pause for over 60 seconds while
storing.
• Do not enter a phone number more than
22 digits long.
Troubleshooting
To Next Page
Loading...
