C
B
A
CBA
Heatweld with the tip of the soldering
iron for 10 seconds each position
(in case of 60W soldering iron) with
10kg pressure applied 3 times on
position (A)~(C)
, as shown belo
w.
Note :
Make sure copper part of solder jig is not
touch the new LCD which will cause burn.
Rubber of Soldering Iron
(Part No. PQZZ430PRB)
Tip of Soldering Iron
(Part No. PQZZ430PIR)
3
To Next Page
Loading...
