Value Range
Max. 16 digits consisting of 0–9, , #, and A–D
Digit Translation Table
Use the Digit Translation Table to translate Follow On ID Signals received from the PBX into the codes needed
by the VPS. This translation table is only effective for incoming signals. Settings made here should correspond
to the Follow On ID settings of the PBX.
Inter-Digit Timeout
Defines the maximum length between the digits of a Follow On ID signal. If this time expires, the VPS will stop
detecting Follow On ID for the call.
Default
1 s
Value Range
1 s–4 s
Translation Table 1–8
Follow the steps below to edit the Translation Table.
1. Click Click to edit....
2. Enter the digits sent from the PBX under "Input Digit" and the corresponding digits received by the VPS
under "Output Digit" in the Translation Table dialog box.
3. Click OK.
Input Digit/Output Digit
Defines the input and output digits that are translated by the Digit Translation Table. Do not assign the same
sequence of Input digits more than once; if this occurs, the VPS will use the first assignment.
Note
• The number of "K" signals assigned for a sequence of Input digits must be the same as the number
entered in the sequence of Output digits.
Default
None
Value Range
Max. 20 digits consisting of 0–9,
, #, A–D, S (Input digit only), and K
S: Skips (ignore) the code; cannot be used as the first character entered.
K: Keeps the code as it is; cannot be entered as the first character under "Input Digit".
160 Programming Manual Document Version 3.0 2010/06
2.5.4 Parameters
To Next Page
Loading...
