1.5 Connect
The Connect menu allows you to directly program the VPS in Interactive mode. When connecting, you are
required to enter the administrator password that corresponds to the programmer code you entered when
starting KX-TVA Maintenance Console.
1.5.1 Connect—Connection Profile
If you have saved a Connection Profile (see 1.9.15 Utility—Profile Setup), you can connect to the VPS using
the settings saved in the profile.
To connect using a Connection Profile
1. From the Connect menu, select Connection Profile.
2. Select the desired profile from the pull-down menu.
3. Enter the password required to connect to the VPS if it was not stored in the Connection Profile.
4. Click Next.
1.5.2 Connect—LAN (TCP/IP) (Optional for KX-TVA50)
Connects to the VPS through the LAN port of the VPS.
Note
• Before you connect to the VPS via LAN, you must first assign an IP address to the VPS. See
1.9.13 Utility—LAN Settings to assign an IP address.
To connect using a LAN
1. From the Connect menu, select LAN (TCP/IP).
2. Enter the IP address, port number, and password used to connect to the VPS.
3. Click Next, and Finish when the connection is completed.
1.5.3 Connect—USB
Connects to the VPS through the USB port on the VPS.
To connect using USB
1. From the Connect menu, select USB.
2. Enter the password used to connect to the VPS.
3. Click Next, and Finish when the connection is completed.
1.5.4 Connect—Dial-up (Modem) (Optional)
Connects to the VPS through the optional modem.
Document Version 3.0 2010/06 Programming Manual 17
1.5.4 Connect—Dial-up (Modem) (Optional)
To Next Page
Loading...
