Panasonic KX-TVA50 - Release for Intercom Paging; No Answer Time for Intercom Paging

Feature Manual References
2.2.25 Intercom Paging (APT/DPT Integration Only)
Release for Intercom Paging
Specifies the intercom paging release sequence. The settings made here must match the settings of the PBX.
The sequence can be a combination of 7 letters and 12 dial codes.
Default
F,
Value Range
Max. 16 digits consisting of 0–9,
, # and special codes
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
,: Dial Pause for 1 s (default)
;: Dial Pause for 3 s (default)
X: Pager Dialing
0–9,
, #: Dial Codes
Feature Manual References
2.2.25 Intercom Paging (APT/DPT Integration Only)
No Answer Time for Intercom Paging
Specifies the length of time (in seconds) the VPS waits before concluding Intercom Paging when there is no
answer. The VPS will return to the caller if the paged party does not respond before this timer expires.
Default
5 s
Value Range
1 s–30 s
Feature Manual References
2.2.25 Intercom Paging (APT/DPT Integration Only)
Announcement Repeat Cycle
Specifies the number of times the VPS announces the page.
Example:
"I have a call for (name)".
Default
1
170 Programming Manual Document Version 3.0 2010/06
2.5.4 Parameters