Panasonic KX-TVA50 - Call Transfer Sequence; No Answer Time

Call Transfer Sequence
Specifies the Call Transfer Sequence used by the mailbox. Allows each mailbox to be assigned its own Call
Transfer Sequence (Personal Transfer Sequence).
Note
• When "System" is selected, the VPS follows the "Extension Transfer Sequence" preprogrammed for
the VPS in "System Parameters®Parameters®PBX Parameters®PBX Environment".
• This sequence has higher priority than "Alternate Extension Transfer Sequence" in 2.5.4.5 PBX
Parameters.
Default
System
Value Range
System
Max. 16 characters consisting of 0–9,
, # and special codes:
D: Disconnecting
F: Flash (Recall)
R: Ringback Tone Detection
T: Dial Tone Detection
, : Dial Pause (default 1 s)
; : Dial Pause (default 3 s)
X: Extension Dialing
0–9,
, #: Dial Code
Programming Manual References
"Extension Transfer Sequence" in 2.5.4.5 PBX Parameters
Feature Manual References
2.3.5 Call Transfer Status
No Answer Time
Specifies the length of time that the VPS waits before handling unanswered calls to the extension.
Note
• When "System" is selected, the VPS follows the "Call Transfer No Answer Time" preprogrammed for
the VPS in the "System Parameters® Parameters® Dialling Parameters".
Default
System
Value Range
System, 10 s – 60 s
Programming Manual References
"Call Transfer No Answer Time" in 2.5.4.5 PBX Parameters
Document Version 3.0 2010/06 Programming Manual 51
2.1.3 Mailbox Parameters