Panasonic KX-W1500 - Page 19

Short Side
Cable Stop
4.1.10 Carrier Cable Winding
Note: . :
Use of Carrier Cable Jig No. PUZXXR250M will make
cable installation much easier, as illustrated.
1. Insert the short end of the cable through the lower
hole and back through the upper hole, pulling until
the cable stops.
2. Wind the short cable end 3 full turns clockwise
around the drum, starting in the first groove and
hold while proceeding with Step “3”.
3. Wind the long cable end 4 full turns counterclock-
wise around the drum, starting in the first groove
from the outside, and hold.
4. Slide the Carrier Cable Jig onto the drum, as illus-
trated, with the cable ends through the Jig
opening.
Note:
@ The cable can be held in place with tape if the Jig is
not available.
@ Pull the Carrier Cable Jig downward to remove.
—~ 18 —