135
DVQP1377
Stabiliser, Zoom and Flash
Correcting jitter
●
When you use a tripod, we recommend setting [Stabilizer] to [OFF].
●
[Stabilizer] cannot be used by selecting [ ] (Normal) in Panorama Shot Mode.
●
In the following cases, the [Stabilizer] will switch to [ ] (Normal), even if it is set to [ ]
(Panning):
• During motion picture recording
• When 4K Photo function has been set
• When recording using [Post Focus]
●
[Stabilizer] cannot be used when recording with [High Speed Video].
●
In “Active Mode”, stronger effect of the correction can be achieved at the wide end.
●
Cases where the stabiliser function may be ineffective:
• When there is a lot of jitter
• When the zoom magnification is high (also in the Digital Zoom range)
• When taking pictures while following a moving subject
• When the shutter speed becomes slower to take pictures indoors or in dark places
●
The panning effect by selecting [ ] is not fully achieved in the following cases:
• Bright summer days or other bright locations
• When the shutter speed is higher than 1/100 seconds
• When the motion of a subject is slow and the speed with which the camera is moved is too slow
(a nice background blur is not achieved)
• When the camera is not adequately tracking the motion of a subject
To Next Page
Loading...
