69
Recording
(ENG) DVQX1072
By attaching an XLR microphone adaptor (DMW-XLR1: optional) to the camera, you can
use a commercially-available XLR microphone to enable the recording of superior-quality
high-res/stereo sound.
Preparations:
• Turn this unit off.
• Remove the hot shoe cover that is attached to the camera. (P53)
∫ Setting the sampling frequency
1 Attach the XLR microphone adaptor to the hot shoe of this unit, and then turn
this unit on.
2 Select the menu. (P24)
• This item is available only when using an XLR microphone adaptor.
• The set sampling frequency is also applied to the sound output via HDMI. With [Sound
Down Convert] in [HDMI Rec Output], you can down-convert the sound output via HDMI.
(P67)
• For details, refer to the operating instructions of the XLR microphone adaptor.
You can record motion pictures while hearing the sounds that are being recorded by
connecting a commercially available headphones to this unit.
∫ Adjusting the headphone volume
Connect headphones, and rotate the control dial while the recording screen is
displayed or a motion picture is being played back.
• You can also adjust the volume by touching [ ] or [ ] during playback.
XLR Microphone Adaptor (optional)
A Hot shoe B XLR microphone adaptor (DMW-XLR1: optional)
C Commercially available XLR microphone
> [Motion Picture] > [XLR Mic Adaptor Setting]
[96kHz/24bit]
Records high-res sound at
96 kHz/24bit.
Only available when [Rec
Format] is set to [MOV].
[48kHz/24bit]
Records high-quality sound at
48 kHz/24bit.
[48kHz/16bit] Records standard-quality sound at 48 kHz/16bit.
[OFF] Records sound using the built-in microphone.
Headphone
: Reduce volume level : Increase volume level
MENU
DC-GH5BodyGN-DVQX1072_eng.book 69 ページ ２０１７年２月１３日 月曜日 午前１１時４５分
To Next Page
Loading...
