Metering / Exposure / ISO Sensitivity – Exposure Compensation
282
• In [M] mode, you can compensate the exposure by setting the ISO sensitivity to
[AUTO].
• When the exposure compensation value falls below or exceeds ±3 EV, the
brightness of the recording screen will no longer change.
Press the shutter button halfway or use AE Lock to reflect the value on the
recording screen.
• The set exposure compensation value is stored even if you turn off the camera.
• The standard value for standard exposure can be adjusted:
(Î[Exposure Offset Adjust.]: 536)
• You can set the exposure compensation value to be reset when the camera is
turned off:
(Î[Exposure Comp. Reset]: 538)
• You can change the operation of the [ ] button:
(Î[WB/ISO/Expo. Button]: 548)
• Exposure Bracket can be set and flash output can be adjusted on the exposure
compensation screen:
(Î[Exposure Comp. Disp. Setting]: 548)
• You can assign the function that matches the aperture value and shutter speed to
the standard exposure to an Fn button:
(Î[One Push AE]: 509)
To Next Page
Loading...
