Getting Started – Charging the Battery
54
• To recover from [Sleep Mode], [Sleep Mode(Wi-Fi)], or [Power Save LVF Shooting],
perform one of the following operations:
– Press the shutter button halfway.
– Set the camera on/off switch to [OFF] and then [ON] again.
• To recover from [Auto LVF/Monitor Off], press any button.
[Sleep Mode] Sets the amount of time until the camera is put to sleep.
[Sleep
Mode(Wi-Fi)]
Sets the camera to sleep 15 minutes after being disconnected
from Wi-Fi.
[Auto LVF/
Monitor Off]
Sets the amount of time it takes for the viewfinder/monitor to turn
off.
(The camera is not turned off.)
[Power Save
LVF Shooting]
Puts the camera to sleep when the recording screen is being
displayed on the monitor when automatic viewfinder/monitor
switching is active.
[Time to Sleep]
Sets the amount of time until the camera is
put to sleep.
[Method of
Activation]
Sets the screen where the camera is put to
sleep.
[Only Control Panel]: Puts the camera to
sleep only when the control panel (ÎControl
Panel: 91) is displayed.
[While Recording Standby]: Puts the
camera to sleep from any screen during
recording standby.
To Next Page
Loading...
