6. Shutter and Drive Settings
166
• When a high ambient temperature, continuous recording or other conditions cause the camera
to overheat, the following restrictions will occur to protect the camera. Wait until the camera
cools down.
– Continuous recording, motion picture recording, and the Wi-Fi connection will be temporarily
disabled.
– If you continue recording even when [ ] is flashing on the screen, a message will be
displayed and the camera will turn off automatically.
• When the burst speed is set to [SH] or [H] (when focus mode is [AFS] or [MF]), the exposure
and White Balance are fixed at the settings used for the first picture for the subsequent pictures
as well.
When the burst speed is set to [H] (when focus mode is [AFF] or [AFC]), [M] or [L], they are
adjusted each time you take a picture.
• Since the shutter speed becomes slower in dark places, the burst speed (pictures/second) may
become slower.
• Depending on the operating conditions, it may take time to take the next picture if you repeat
the recording of pictures.
• It may take time to save pictures taken in Burst Mode on the card. If you take pictures
continuously while saving, the maximum number of recordable pictures decreases. For
continuous shooting, use of a high speed memory card is recommended.
Not available in these cases:
•
The Burst Mode is disabled in the following cases.
– [Glistening Water]/[Glittering Illuminations]/[Handheld Night Shot]/[Soft Image of a Flower]
(Scene Guide Mode)
– [Rough Monochrome]/[Silky Monochrome]/[Miniature Effect]/[Soft Focus]/[Star Filter]/
[Sunshine] (Creative Control Mode)
– In Self Shot Mode
– When White Balance Bracket is set
– When recording motion pictures
– When recording using the flash
– When recording with the shutter speed set to [T] (Time)
– When recording with [iHandheld Night Shot]
– When [HDR] is set to [ON]
– When using [Multi Exp.]
– When using [Time Lapse Shot]
– When using [Stop Motion Animation] (only when [Auto Shooting] is set)
– When [Simultaneous record w/o filter] of [Filter Settings] is set to [ON]
• In the following cases, [SH] in Burst Mode cannot be used.
– When [Quality] is set to [ ], [ ] or [ ]
– When using [Stop Motion Animation]
To Next Page
Loading...
