Recording
- 67 -
∫ About the screen display underwater
A Depth meter
• Depth meter will display the depth up to 12 m (40 feet) in 3 levels.
• Camera will automatically set to the optimal picture quality for underwater from the depth
information. Icons showing the picture quality will switch in such a case.
About the fine adjustment of the white balance
Color can be adjusted in accordance with the depth or weather. For details, refer to “Finely
adjusting the White Balance” on P102.
Note
•
Measured depth may not be accurate when pressure is applied to front or rear of this unit by
pressing with your hands, etc. In such a case, it is recommended to perform [Depth indicator]
again when you get back to the surface.
• To prevent water leakage, make sure that there are no foreign objects, such as sand, hair, dust,
etc., clamped and close the side door all the way until it clicks. Also, read
“(Important) About
the Waterproof/Dustproof and Anti-shock Performance of the Camera
” (P8) before using the
camera.
• Dip the camera in fresh water in a shallow container for 10 minutes or less after using it, then
wipe the water off with dry soft cloth. (P11)
When the third level is flashing
You are approaching a depth of 12 m (40 feet), which is
the diving limit of this unit. Please be aware.
Entire depth meter is flashing You have exceeded a depth of 12 m (40 feet).
[]
It is adjusted to optimal picture quality for underwater up to a depth of 3 m
(10 feet) when [ ] is displayed.
[]
It is adjusted to optimal picture quality for underwater for a depth of 3 m (10 feet)
to 12 m (40 feet) when [ ] is displayed.
To Next Page
Loading...
Need help?
General
