Recording
- 91 -
Note
•
It may not measure correctly when you measure with this unit upside down.
• The bearing measurement value may be affected in locations with weak geomagnetism.
• It may not measure accurately if close to the following objects:
–Permanent magnets (metals in magnetic necklaces, etc.)/metallic objects (steel desks,
lockers, etc.)/high-voltage lines or overhead wires/household appliances (TVs, PCs,
speakers, etc.)
• It may not measure accurately in the following locations:
–Inside cars/trains/ships/aeroplanes/rooms (when the steel beams are magnetized)
The bearing may not be measured due to disturbance of the geomagnetism depending on
the environment, such as when there is something emitting strong magnetism nearby, etc.
[ ] is displayed on the compass when the bearing cannot be measured, and a message
prompting to adjust is displayed. In such a case, perform [Calibrate compass].
Select [Calibrate compass] from the [GPS/Sensor] menu. (P44)
Securely hold the unit vertically, and
adjust by turning it in a figure 8 a few
times rolling your wrist.
• An adjustment completed message is
displayed when the adjustment is successful.
Note
•
Perform the adjustment with the strap around your wrist to avoid dropping the unit.
• When the adjustment fails, move to a location with no effect from surrounding magnetism, and
perform the adjustment again.
Adjusting the compass
To Next Page
Loading...
Need help?
General
