Step 3
With the screen flipped over, you now have access to the metal plate under it. Using the same
Phillips screwdriver, remove the metal plate. Doing this will give you access to the push pin
holding the cover in place.
Use a small needle, pin, or needle nose pliers to slide the pin right out. Be sure to keep the pin and
spring in a safe spot to prevent loss.
Step 4
Once you have replaced the the pin
and spring with the new cover, be
sure to check that the spring action
still functions. Also check that the
battery sits properly in the
compartment and the cover locks
and fits properly.
To Next Page
Loading...
